Restoring Factory Settings In Computer Setup - HP ProBook 640 G1 Maintenance And Service Manual
Hide thumbs
Also See for ProBook 640 G1:
- Overview (61 pages) ,
- Maintenance and service manual (166 pages)
Table of Contents
Advertisement
1.
Turn on or restart the computer, and then press
message is displayed at the bottom of the screen.
NOTE:
to navigate and make selections in Computer Setup.
2.
press
●
To select a menu or a menu item, use the
press enter, or use a pointing device to click the item.
●
To scroll up and down, click the up arrow or the down arrow in the upper-right corner of the
screen, or use the up arrow key or the down arrow key on the keyboard.
●
To close open dialog boxes and return to the main Computer Setup screen, press esc, and then
follow the on-screen instructions.
To exit Computer Setup menus, choose one of the following methods:
●
To exit Computer Setup menus without saving your changes:
Click the Exit icon in the lower-right corner of the screen, and then follow the on-screen instructions.
- or -
Use the
●
To save your changes and exit Computer Setup menus:
Click the Save icon in the lower-right corner of the screen, and then follow the on-screen instructions.
- or -
Use the
Your changes go into effect when the computer restarts.
Restoring factory settings in Computer Setup
NOTE:
Restoring defaults will not change the hard drive mode.
To return all settings in Computer Setup to the values that were set at the factory, follow these steps:
1.
Turn on or restart the computer, and then press
message is displayed at the bottom of the screen.
2.
press
3.
Use a pointing device or the arrow keys to select Main > Restore Defaults.
4.
Follow the on-screen instructions.
5.
To save your changes and exit, click the Save icon in the lower-right corner of the screen, and then
follow the on-screen instructions.
- or -
Use the arrow keys to select Main > Save Changes and Exit, and then press enter.
Your changes go into effect when the computer restarts.
NOTE:
Your password settings and security settings are not changed when you restore the default settings.
122 Chapter 9 Computer Setup
You can use either a pointing device (TouchPad, pointing stick, or USB mouse) or the keyboard
f10
to enter Computer Setup.
tab
key and the arrow keys to select Main > Ignore Changes and Exit, and then press enter.
tab
key and the arrow keys to select Main > Save Changes and Exit, and then press enter.
f10
to enter Computer Setup.
esc
while the "press the ESC key for Startup Menu"
tab
key and the keyboard arrow keys and then
esc
while the "press the ESC key for Startup Menu"
Advertisement
Table of Contents
