a.
Service cover (see
b.
Hard drive (see
c.
Optical drive (see
d.
Keyboard (see
e.
Base enclosure (see
f.
USB board (see
g.
Speakers (see
h.
Fan and heat sink assembly (see
Remove the power connector cable:
1.
Disconnect the power connector cable (1) from the system board.
2.
Release the power connector cable (2) from the clips built into the base enclosure.
3.
Release the power connector (3) from the clips and mold built into the base enclosure.
4.
Remove the power connector cable.
Reverse this procedure to install the power connector cable.
102 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Service cover on page
Hard drive on page
58)
Optical drive on page
Keyboard on page
72)
Base enclosure on page
USB board on page
85)
Speakers on page
95)
Fan and heat sink assembly on page
57)
69)
82)
79)