Rear Panel Ports, Buttons, Antennas, And Connector - NETGEAR EX6200 User Manual

Table 1. Front panel LEDs
LED
Device to Extender
LED
USB LED

Rear Panel Ports, Buttons, Antennas, and Connector

The following figure shows the ports, buttons, antennas, and connector on the rear panel of
the extender.
WPS button
Figure 3. Rear panel
AC1200 WiFi Range Extender
Description
Green. The extender is connected to a computer or WiFi device.
Note: If you press the WPS button on the rear panel of the extender, the LED
blinks green for two minutes.
Amber. The extender is starting or is applying WiFi settings. After about one
minute, the LED turns green.
During the startup process, both Link Rate LEDs also light amber. After about
one minute, these LED light green or turn off, depending on the WiFi
connection between the extender and the WiFi network.
Note: The Device to Extender LED blinks amber during a firmware update.
Off. The extender is not connected to a computer or WiFi device.
Solid green. A USB device is connected to the USB port.
Off. No USB device is connected to the USB port.
Two preinstalled 5dBi antennas
Ethernet LAN ports
Restore Factory Settings button
Overview
9
On/Off button Power connector