Attach The Rubber Feet - NETGEAR EX6200 User Manual


To attach the stand:
1. Place the stand on a flat surface.
2. Hold the extender in upright position with the left side of the extender pointing down. (The
left side has three rectangular openings.)
The top panel of the extender and the three vertical support posts of the stand must face
the same direction.
3. Lower the extender onto the stand until the support posts of the stand snap into the
rectangular openings of the extender.

Attach the Rubber Feet

If you prefer to place the extender in horizontal position, you can attach the rubber feet that
come with the extender.
Figure 5. Attaching the rubber feet

To attach the rubber feet:
1. Place the extender upside down, with the red panel facing you. (The red panel is the
bottom.)
2. In each corner, attach a rubber foot in such a way that it covers the triangle.
AC1200 WiFi Range Extender
Overview
11