Table of Contents
Advertisement
Connector board
Description
Connector board (includes cable, USB port, memory card reader, audio jack, and double-sided adhesive)
Before removing the connector board, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the keyboard/top cover (see
5.
Disconnect the battery cable from the system board (see
Remove the connector board:
1.
Release the ZIF connector (1) to which the connector board cable is attached, and then disconnect
the connector board cable from the system board.
2.
Detach the connector board cable (2) from the base enclosure. (The connector board cable is attached
to the base enclosure with double-sided adhesive.)
3.
Remove the Philllips PM2.0×3.3 screw (3) that secures the connector board to the base enclosure.
4.
Remove the connector board (4).
Reverse this procedure to install the connector board.
40
Chapter 5 Removal and replacement procedures
Keyboard/top cover on page
Battery on page
Spare part number
809788-001
20).
26).
Advertisement
Table of Contents
