System Board - HP 11t-f000 Maintenance And Service Manual

System board

NOTE: The system board spare part kit includes a graphics subsystem with UMA memory, 2.0-GB of system
memory, and replacement thermal material.
Description
Equipped with an Intel Celeron N2840 2.16-GHz processor (1.00-MB L2 cache, dual core, 7.5 W)
and the Windows 10 or Windows 8 Standard operating system
Equipped with an Intel Celeron N2840 2.16-GHz processor (1.00-MB L2 cache, dual core, 7.5 W)
and the Windows 10 or Windows 8 Standard operating system
Equipped with an Intel Celeron N2840 2.16-GHz processor (1.00-MB L2 cache, dual core, 7.5 W) and a
non-Windows operating system
Before removing the system board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the keyboard/top cover (see
5. Disconnect the battery cable from the system board (see
6. Remove the WLAN module (see
Remove the system board:
1. Disconnect the following cables from the system board:
(1) Power connector cable
(2) Hard drive ZIF cable
(3) Connector board ZIF cable
(4) Display panel ZIF cable
(5) Speaker cable
38 Chapter 5 Removal and replacement procedures
Keyboard/top cover on page
WLAN module on page 29).
Spare part number
809793-601
809793-501
809793-001
20).
Battery on page 26).