Table of Contents
Advertisement
Power connector cable
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the keyboard/top cover (see
5.
Disconnect the battery cable from the system board (see
Remove the power connector cable:
1.
Disconnect the power connector cable (1) from the system board.
2.
Release the power connector cable from the retention clips (2) built into the base enclosure.
3.
Release the power connector (3) from the retention clips built into the base enclosure.
4.
Remove the power connector cable.
Reverse this procedure to install the power connector cable.
Keyboard/top cover on page
Battery on page
Spare part number
806746-001
20).
26).
Component replacement procedures
31
Advertisement
Table of Contents
