Table of Contents
Advertisement
NOTE:
black WLAN antenna cable connects to the WLAN module #1/Aux terminal.
2.
Remove the Phillips PM2.0×3.3 screw (2) that secures the WLAN module to the base enclosure. (The
WLAN module tilts up.)
3.
Remove the WLAN module (3) by pulling the module away from the slot at an angle.
NOTE:
If the WLAN antenna is not connected to the terminal on the WLAN module, a protective sleeve must
be installed on the antenna connector, as shown in the following illustration.
Reverse this procedure to install the WLAN module.
30
Chapter 5 Removal and replacement procedures
The #1/white WLAN antenna cable connects to the WLAN module #1/Main terminal. The #2/
Advertisement
Table of Contents
