Touchdown; Throttle; Balked Landing (Go-Around) - Cub Crafters CC18-180 Pilot Operating Handbook

SECTION 4
NORMAL PROCEDURES
4.3.3.6.2 Cross-Wind Landing
 Fuel Selector ........................................................ Both
 Seat Belts ..................................................... Fastened
 Mixture ................................................................... Set
 Flaps ............................................. Set below white arc
INDICATED AIRSPEED (IAS)
Maximum Speed 1st Notch Flaps (22°)
Maximum Speed Full Flaps (50°)
 Trim ........................................................... As required
 Speed ........................................................ As required
(A higher speed than normal is recommended)
 Ailerons-Rudder ..................................... On short final
 Touchdown ....................... Do not touch down in a slip
 Landing Roll ............ Use ailerons to keep upwind wing

4.3.3.7 Balked Landing (Go-Around)

 Throttle........................................................ Full power
 Airspeed
 Flaps ...................................................... Retract slowly
 Trim ........................................................... As required
REPORT TC10000AFM
Page Number: 4-14
Use ailerons to keep upwind wing low
Rudder to hold runway alignment
MPH
Above 54
CUB CRAFTERS
MPH
down, rudder and brakes to
maintain directional control
KNOTS
Above 47
Issued: 05/31/05
Date of Revision: 11/20/12
CC18-180
KNOTS
98 85
89 77