CUB CRAFTERS
CC18-180
4.3.2.2 Starting Engine
Battery Master Switch ............................................. On
Beacon ................................................................... On
Ignition Switch....................................................... Both
Mixture ............................................................. Full rich
Primer ................................................................ Apply*
Throttle .................................................. Open 1/2 inch
Starter ............................................................. Engage
After engine has started,
Oil pressure ....................................................... Check
Throttle ................................................. Set 1000 RPM
Lights ......................................................... As required
Avionics master switch ............................................ On
*Normal procedure 3 times. If engine is hot, omit this
step.
Ensure that the primer is closed and locked after the
engine has started. Applying the primer with the
engine running will make the engine stop.
4.3.2.3 Starting Engine When Flooded
Ignition Switch....................................................... Both
Mixture ........................................................ Idle cut-off
Throttle ......................................................... Full open
Starter ............................................................. Engage
When engine fires,
Mixture .................................................................. Rich
Throttle ........................................ Retard to 1000 RPM
Oil Pressure ....................................................... Check
Lights ......................................................... As required
Avionics Master Switch ........................................... On
Issued: 05/31/05
Date of Revision: 11/20/12
NORMAL PROCEDURES
WARNING
SECTION 4
REPORT TC10000AFM
Page Number: 4-9