Cub Crafters CC18-180 Pilot Operating Handbook page 393

CUB CRAFTERS
CC18-180
9.13.4.4.19
 Fuel selector ......................................................... Both
 Seat belts ...................................................... Fastened
 Mixture .................................................................... Set
 Flaps ............................................. Set below white arc
AIRSPEED (IAS)
Maximum speed first notch flaps (22°)
Maximum speed full flaps (50°)
 Trim ............................................................ As required
 Speed ........................................................ As required
(A higher speed than normal is recommended)
 Ailerons-rudder ....................................... On short final
 Touchdown ....................... Do not touch down in a slip
 Landing roll ............ Use ailerons to keep upwind wing
down, and rudder to maintain directional control
9.13.4.4.20
 Throttle ........................................................ Full power
 Airspeed Above
 Flaps ...................................................... Retract slowly
 Trim ............................................................ As required
9.13.4.4.21
 Flaps ................................................................ Retract
 Electrical equipment ............................................... Off
 Avionics master switch ........................................... Off
 Throttle ................................................................... Idle
Issued: 10/09/12
Date of Revision: 09/15/15
SUPPLEMENTS- WIPAIRE 2100S
Cross Wind Landing
Use ailerons to keep upwind wing low
Go-around
(IAS)
Stopping Engine
SECTION 9.13
SEAPLANE FLOATS
MPH
98
89
Rudder to hold alignment
as appropriate
MPH
54
REPORT TC10000AFM
Page Number: 9-13-19
KNOTS
85
77
KNOTS
47