Cub Crafters CC18-180 Pilot Operating Handbook page 390

SECTION 9.13
SUPPLEMENTS-WIPAIRE 2100S
SEAPLANE FLOATS
9.13.4.4.11
 Taxi area ............................................................. Clear
 Throttle ..................................................... Apply slowly
 Pitot heat (if required) ............................................. On
9.13.4.4.12
 Throttle ...................................................... 1700 RPM*
 Ignition ............................................................... Check
Drop not to exceed 175 RPM or 50 RPM differential
between magnetos and no engine roughness
 Carburetor heat ........ Hot, note RPM drop and remove
 Engine instruments ........................................... Check
 Ammeter ............................................................ Check
 Throttle ........................................................ Check idle
 Throttle ........................................................ 1000 RPM
 Flight instruments .............................................. Check
 Fuel selector ............... Both and sufficient qty for flight
 Engine gauges .................................................. Check
 Mixture .................................................................. Set*
 Ignition .................................................................. Both
 Carburetor heat ............................................. Off (cold)
 Primer ............................................................... Locked
 Trim ........................................................................ Set
 Flaps ...................................... First notch (takeoff 22°)
 Controls ............................ Free and proper movement
 Doors ................................................................ Closed
 Strobes and lights ..................................... As required
 Transponder and other avionics .............................. On
 Seat belts ............................................ Check fastened
* When operating at high altitudes and/or temperatures, it
may be necessary to lean the mixture for peak RPM.
REPORT TC10000AFM
Page Number: 9-13-16
Taxiing
Before Takeoff
CUB CRAFTERS
Issued: 10/09/12
Date of Revision: 09/15/15
CC18-180