Cub Crafters CC18-180 Pilot Operating Handbook page 329

CUB CRAFTERS
CC18-180
9.11.4.4.22
 Fuel selector ......................................................... Both
 Seat belts ..................................................... Fastened
 Mixture ................................................................... Set
 Flaps ............................................ Set below white arc
AIRSPEED (IAS)
Maximum speed first notch flaps (22°)
Maximum speed full flaps (50°)
 Landing gear .......................................... Up for water
 Landing gear lights ....................... Four Blue for water
 Trim ........................................................... As required
 Speed ........................................................ As required
(A higher speed than normal is recommended)
 Ailerons-rudder ....................................... On short final
 Touchdown ....................... Do not touch down in a slip
 Landing roll ............ Use ailerons to keep upwind wing
down, rudder and brakes to maintain directional
9.11.4.4.23
 Throttle ....................................................... Full power
 Landing gear .................................................. Retract
AIRSPEED (IAS)

Airspeed Above
 Flaps ..................................................... Retract slowly
 Trim ........................................................... As required
Issued: 5/31/05
Date of Revision: 09/15/15
SUPPLEMENTS- WIPAIRE 2100A
Cross Wind Landing
...................................... Down for runway
.......................... Four Green for land
Use ailerons to keep upwind wing low
Rudder to hold runway alignment
Go-around
SECTION 9.11
AMPHIBIOUS FLOATS
MPH
98
89
control as appropriate
MPH
54
REPORT TC10000AFM
Page Number: 9-11-27
KNOTS
85
77
KNOTS
47