Cub Crafters CC18-180 Pilot Operating Handbook page 321

CUB CRAFTERS
CC18-180
9.11.4.4.4
 Nose gear and springs ...................................... Check
 Chocks ......................................................... Removed
 Main landing gear shock absorber and tire ....... Check
 Main landing gear brakes and lines .................. Check
 Float hatches ........ Cargo secure and hatches latched
 Float.............Check for damage and water accumulation
Remove rubber plugs which serve as stoppers on the
standpipe in each float compartment and pump out any
accumulation of water. Reinstall rubber plugs with
enough pressure for a snug fit.
 Bilge rubber plugs ............................................ Secure
 Fuel tank ............... Check supply and cap for security
 Fuel vent ........................................................... Check
 Tie down ......................................................... Remove
 Landing light ...................................... Check condition
 Pitot tube ........................................... Check condition
 Wing tip and light ............................... Check condition
 Vortex generators .............................................. Check
 Aileron hinges ................................................... Check
 Aileron surface .................................. Check condition
 Flap hinges ........................................................ Check
 Flap surface ...................................... Check condition
 Tank sump ......................................................... Drain
 Water rudders and cables ................................. Check
 Left fuselage ...................................................... Check
Issued: 5/31/05
Date of Revision: 09/15/15
SUPPLEMENTS- WIPAIRE 2100A
Preflight Left Fuselage, Wing, and Float
AMPHIBIOUS FLOATS
(use bilge pump as necessary)
NOTE
REPORT TC10000AFM
Page Number: 9-11-19
SECTION 9.11