Cub Crafters CC18-180 Pilot Operating Handbook page 297

CUB CRAFTERS
CC18-180
If not previously defined, the following default settings
must be made in the "SETUP 1" menu of the GNS 430
prior to operation (refer to Pilot's Guide for procedure if
necessary):

dis, spd:
units to "nautical miles" and "knots" or "statute
miles" and "mph")

alt, vs:
and "feet per minute")

map datum: WGS 84 (sets map datum to WGS-
84, see note below)

posn:
to decimal minutes)
In some areas outside the United States, datums other
than WGS-84 or NAD-83 may be used. If the GNS 430 is
authorized for use by the appropriate Airworthiness
Authority, the required geodetic datum must be set in the
GNS 430 prior to its use for navigation.
Navigation must not be predicated upon the use of
TERRAIN.
The Terrain display is intended to serve as a
situational awareness tool only. It may not provide
either the accuracy or fidelity, or both, on which to
solely base decisions and plan maneuvers to avoid
To avoid giving unwanted alerts, TERRAIN must be
inhibited when landing at an airport that is not included in
the airport database.
Issued: 5/31/05
Date of revision: 12/06/05
nm, kt or mi, mph (sets navigation
ft fpm (sets altitude units to "feet"
deg-min (sets navigation grid units
NOTE:
CAUTION
terrain or obstacles.
SECTION 9.10
SUPPLEMENTS-GNS 430
REPORT TC10000AFM
Page number 9-10-5