Cub Crafters CC18-180 Pilot Operating Handbook page 231

CUB CRAFTERS
CC18-180
With the Fuel Flow Option (installed in the EDM-800),
instead of seeing the word LF in the display, you will see
numerical fuel flow rate during the leaning process on the
right side of the digital display.
observe the EGT rise and at the same time watch the fuel
flow rate decrease. To show the progress of the leaning
process, the EDM selects the hottest cylinder for
reference in the digital display. In the example in Figure
9-4-6, 1360 is the current temperature of the hottest
cylinder and the fuel flow is 13.8.
When LF is activated:
Cylinder number of
hottest cylinder
flashes when EGT
rises 15
Dot indicates
hottest cylinder
temperature and
fuel flow displayed
Continue leaning slowly without pausing. Lean slowly and
smoothly. Eventually, one cylinder will reach peak before
any of the other cylinders. The EDM will determine this
automatically.
necessarily have the hottest EGT.
Issued: 5/31/05
Date of revision: 12/06/05

SO
400
300
1360 13.8
STEP
Figure 9-4-6 Leaning Example
Notice that this
SUPPLEMENTS-EDM-800
This allows you to
HP
73
3 4 5 6
J P I
EDM 800
cylinder
REPORT TC10000AFM
Page number 9-4-19
SECTION 9.4
F
T
EGT
%
Limit
LF
does not