Cub Crafters CC18-180 Pilot Operating Handbook page 225

CUB CRAFTERS SECTION 9.4
CC18-180 SUPPLEMENTS-EDM-800
9.4.7.3.2 Manual Mode
Tap the STEP button. Use the Manual mode when you
want to monitor one specific parameter such as shock
cooling during descent, or a particular cylinder
temperature during climbs. To change to the Manual
mode, tap the STEP button once. Subsequent taps will
index the digital display through the parameter. To exit
the Manual mode and return to the Automatic mode,
either tap the LF button and then tap the STEP button or
wait 5 minutes. You may disable the Automatic mode by
setting "0" for scan rate.
9.4.7.3.3 LeanFind Mode
Please refer to section 9.4.7.9.
9.4.7.4 Display Dimming
The entire display panel features automatic dimming.
Allow ten seconds for the display to adjust to ambient
lighting conditions.
9.4.7.5 Fuel Flow Display Select Switch
The select switch is a three-position toggle switch
mounted on your instrument panel near the display of the
EDM. It affects only the display scan (Figure 9-4-1).
● In the EGT position only the installed temperature
(and battery voltage) parameters are displayed.
REPORT TC10000AFM
Issued: 5/31/05
Date of revision: 12/06/05 Page number 9-4-13