Cub Crafters CC18-180 Pilot Operating Handbook page 222

SECTION 9.4
SUPPLEMENTS-EDM-800

LF Button
Located on the lower right side near the instrument face.
● In Automatic or Manual modes (see section 9.4.7.3),
tapping the LF button will change to the LeanFind mode.
● In Automatic or Manual modes holding the LF button
for three seconds will toggle between Percentage and
Normalize views.
● In the LF mode (see section 9.4.7.9), holding the LF
button after peak EGT is found will display peak EGT.
● In the LF mode tapping both the STEP and LF buttons
simultaneously will mark a data record in long term
memory and display will flash SNAP.

STEP and LF Buttons
● Holding both the STEP and LF buttons simultaneously
for five seconds changes to the pilot programming
procedure.
● Holding both the STEP and LF buttons simultaneously
for five seconds after entering LeanFind mode (see
section 9.4.7.9), but before beginning to lean will toggle
between leaning "rich of peak" and "lean of peak."
●
Tapping
simultaneously in Manual mode (see section 9.4.7.3),
toggles to include or exclude the displayed parameter
from the Automatic mode.
displayed parameters in the Manual mode.
REPORT TC10000AFM
Page number 9-4-10
both the STEP
CUB CRAFTERS
and LF
It has no affect on the
Date of revision: 12/06/05
CC18-180
buttons
Issued: 5/31/05