Cub Crafters CC18-180 Pilot Operating Handbook page 221

CUB CRAFTERS SECTION 9.4
CC18-180 SUPPLEMENTS-EDM-800
 Percent HP or RPM
Displays percent of rated HP or RPM depending on pilot
programming.
Beneath the bar graph is the 9-segment alphanumeric
display.
9.4.7.2 Buttons
1340 376
STEP LF
J
I P
EDM 800
STEP button
LF button
Figure 9-4-3 EDM-800 Buttons
NOTE
The term tap is used to denote pressing a button
momentarily. The term hold is used to denote pressing
and holding a button for five seconds or longer.

STEP Button
The STEP button is located on the lower left side near
the instrument face.
In the Automatic mode (see section 9.4.7.3), tapping the
STEP button will stop and change to the Manual mode.
Then each tap of the STEP button will display the next
parameter in the sequence.
In the LeanFind mode (see section 9.4.7.9), tapping the
STEP button will terminate the LeanFind mode and
change to the Automatic mode.
REPORT TC10000AFM
Issued: 5/31/05
Date of revision: 12/06/05 Page number 9-4-9