Cub Crafters CC18-180 Pilot Operating Handbook page 219

CUB CRAFTERS SECTION 9.4
CC18-180 SUPPLEMENTS-EDM-800
initially set to the same half-height level for trend
analysis. Any changes are shown as an increase or
decrease in column height. A one segment change in
column height represents a 10°F change. The Normalize
view permits rapid visualization of EGT trends, rather
than as a percentage of maximum EGT. You can use
normalize in level cruise and run-up.
To toggle between Percentage and the Normalize views,
hold the LF button for five seconds until the display
changes. The bar display becomes half height and the
display changes to the Normalize view. Selecting the
Normalize view does not affect the digital display nor alter
the parameter sequence. The CHT display—described
later—is not affected by the Normalize or Percentage
view.
You may select the Normalize view in either the Manual
or Automatic mode (see 9.4.7.3). Normalize view is most
helpful for engine trend monitoring of each cylinder's
operation. For example using the Normalize view during
engine run-up, a fouled spark plug will appear as a higher
column.
A common misapplication is to be in the Normalize view
and then change your power setting, causing all columns
to go off scale, high or low. Set to the Percentage view
before adding or reducing power. Always set Percentage
View when beginning your descent.
REPORT TC10000AFM
Issued: 5/31/05
Date of revision: 12/06/05 Page number 9-4-7