Optional External Devices
The jacks and connectors described in this guide support standard
external devices.
■
For information about which jack or port to use, refer to the
documentation included with the device.
■
For information about installing or loading any software
required by the device, such as drivers, refer to the
documentation included with the device.
To connect a standard external device to the notebook:
1. Turn off the notebook. (If you are not sure whether the
notebook is off or in hibernation, turn on the notebook by
sliding the power switch toward the front of the notebook.
Then shut down the notebook through the operating system.)
2. If you are connecting a powered device, turn off the device.
3. Connect the device to the notebook.
4. If you are connecting a powered device, plug the device
power cord into a grounded electrical outlet.
5. Turn on the device.
6. Turn on the notebook.
To disconnect a standard external device from the notebook, turn
off the device, and then disconnect it from the notebook.
Optional External MultiBay and External
MultiBay II
An external MultiBay or MultiBay II connects to the notebook
USB port and enables you to use MultiBay and MultiBay II
devices. The notebook provides one powered USB port on the
right side. This port provides power to the external MultiBay
when used with a powered USB cable. The USB ports on the rear
panel and left side of the notebook do not provide power to the
external MultiBay. External MultiBays connected to these USB
ports must be connected to AC power.
Hardware and Software Guide
Drives
5–9