Table of Contents
Advertisement
Speakers
Description
Speaker Kit (includes left and right speakers and cable)
Before removing the speakers, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the bottom cover (see
5.
Disconnect the battery.
Remove the speakers:
1.
Disconnect the speaker cable from the system board (1).
2.
Release the speaker cable (2) from the clips on the battery.
3.
Remove the four Phillips PM2.0×6.0 broad head screws (3) that secure the speakers to the computer.
NOTE:
gaskets are properly installed.
32
Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Bottom cover on page
Make note of the rubber gaskets (4) that fit around each screw. For installation, make sure the
23).
Spare part number
794298-001
Advertisement
Table of Contents
