Setup / Batteries - Health O Meter 1100KL User Instruction

SETUP / BATTERIES

Preparing the 1100KL Scale for Use
1. Remove the protective plastic film covering the display (the film says "FACTORY
CALIBRATED").
2. Place batteries into the battery holder (see "Replacing / Inserting Batteries" information
below).
3. Connect the AC adapter into the adapter jack on the display assembly.
Warning: To avoid a safety hazard, use AC adapter model ADPT30.
4. Plug the scale's AC adapter into the power source.
5. Ensure all objects are removed from the scale's platform, and then press the ON/OFF button
to power the scale on. The display will show "Start", then "0.0" LB or "0.0" KG. Press the UNIT
button to select the weight mode (LB or KG).
Note: This scale will always default to the settings and units last used (LB or KG).
6. When the AC adapter is disconnected from the scale, the scale will switch to battery power if
batteries are installed.
Note: If the set up procedure failed, refer to the troubleshooting instructions. If the problem is
not corrected, refer to qualified service personnel.
Replacing / Inserting Batteries
1. Unplug the AC adapter from the power source.
2. Remove the battery cover on the side of the display assembly by unscrewing the (2) battery
cover screws (see Figure 7 on page 11).
3. Replace or install the batteries with new units. Health o meter recommends using an alkaline
or lithium battery, rated for 130°F (54°C) operation. Do not use Zinc-Carbon batteries.
4. Re-attach the battery cover to the display assembly.
Warning: If the scale will not be used for some time, remove the batteries to avoid a
safety hazard. Disposal of batteries must be performed in accordance with the prevailing
national, regional or local regulations which apply to you.
12