Looking For Blockages; Cleaning The Clear Bin; Clearing Brush Bar Obstructions; Washing Your Filter - Dyson DC23 Operating Manual

USINg YOUR dYSON vACUUM ClEANER
CAUTION:
• Always turn 'OFF' this vacuum cleaner before connecting or disconnecting either hose
or nozzle.
PLeASe NOTe:
• The hose contains electrical wires. Do not use when damaged, cut or punctured. Avoid
picking up sharp objects.
• Do not use or store this machine below 32˚F (0˚C). ensure that the machine is at room
temperature before operating.
• Do not allow use by anyone unable to operate the vacuum cleaner properly.
• Consult your flooring manufacturer's recommended instructions before vacuuming
and caring for your flooring, rugs and carpets. Some carpets will fuzz if a rotating
brush bar is used when vacuuming. If this happens, we recommend vacuuming in bare
floors mode and consulting with your flooring manufacturer.
• The brush bars will reset to 'ON' each time you start the vacuum cleaner and put it in
the cleaning position.
• This vacuum cleaner is designed for domestic indoor and car use only; it should not be
used or stored outdoors. It should not be used for commercial or rental purposes.
• Do not use your vacuum cleaner outdoors or on wet surfaces, or to vacuum water or
other liquids - electric or personal injury could occur.
• The vacuum cleaner may be used inside a garage only with the Model 08909 Dyson
Car Cleaning Kit accessories. If used in a garage, care should be taken to wipe the
soleplate and wheels with a dry cloth after vacuuming to clean off any sand, dirt or
pebbles which could damage delicate floors.
• Switch off and unplug the vacuum cleaner before changing accessories, removing
the clear bin, filters, hose, checking for blockages or before performing any other
maintenance operation.
• Fine dust such as plaster dust or flour should only be vacuumed in very small amounts.
• Do not press the cyclone release button while carrying the vacuum cleaner or it could
fall and cause injury.
• Do not use the vacuum cleaner to pick up sharp hard objects, small toys, pins, paper
clips etc., because they may damage the vacuum cleaner.
• When vacuuming, certain carpets may generate small static charges in the clear bin or
wand. These are not associated with the electricity supply. To minimize any effect from
this, do not put your hand or insert any object into the clear bin unless you have first
emptied it and rinsed it out with cold water.
• Do not use any lubricants, cleaning agents, polishes or air fresheners on any part of
the appliance.
EMPTYINg ThE ClEAR bIN
CAUTION:
• Switch 'OFF' and unplug the vacuum cleaner before emptying the clear bin.
• Empty as soon as the dirt reaches the level of the MAX mark – do not overfill. To
remove the clear bin from the vacuum cleaner press the button at rear of cyclone
carrying handle.
To release the dirt, press the red clear bin release button.
PLeASe NOTe:
• Do not use the vacuum cleaner without the clear bin in place.
• To minimize dust/allergen contact when emptying, encase the clear bin tightly in a
plastic bag and empty. Remove the clear bin carefully and seal bag tightly, dispose as
normal.

ClEANINg ThE ClEAR bIN

CAUTION:
• Do not immerse the whole cyclone in water or pour water into the cyclones.
• ensure the clear bin is completely dry before replacing.
• Clean the shroud with a cloth or dry brush to remove lint and dust.
PLeASe NOTe:
• Do not use detergents, polishes or air fresheners to clean the clear bin.
• Do not put clear bin in a dishwasher.

WAShINg YOUR FIlTER

Do ThiS AT LEAST EVERy 3 MoNThS
CAUTION:
• Switch 'OFF' and unplug the vacuum cleaner before removing the filter.
• ensure filter is completely dry before refitting to the vacuum cleaner.
PLeASe NOTe:
• It is important to check your filter regularly and wash at least every 3 months
according to instructions, to maintain performance.
• Please leave to dry completely for 24 hours.
• The filter may require more frequent washing if vacuuming fine dust.
• Do not use detergents to clean the filter.
• Do not put the filter in a dishwasher, washing machine, tumble dryer, oven, microwave
or near an open flame.
8

lOOKINg FOR blOCKAgES

CAUTION:
• Switch 'OFF' and unplug the vacuum cleaner before checking for blockages. Failure to
do so could result in personal injury.
• Please ensure the vacuum cleaner is upright and switched off before removing hose or
airway inspection parts.
• Beware of sharp objects when clearing blockages.
• Refit all parts of the vacuum cleaner securely before using.
PLeASe NOTe:
• Clearing blockages is not covered by your vacuum's limited warranty.
• This vacuum is fitted with an automatically resetting thermal cut-out. If any part of your
vacuum becomes blocked, it may overheat and then automatically shut off. Switch
'OFF' and unplug the vacuum and leave to cool down for at least 60 minutes before
attempting to check filters or for blockages. Clear blockage before restarting.
• Large items may block the tools or wand inlet, if this happens switch the vacuum
cleaner off and unplug the vacuum before removing the blockage. Do not operate the
wand release catch.
2
1
3

ClEARINg bRUSh bAR ObSTRUCTIONS

CAUTION:
• Switch 'OFF' and unplug the vacuum cleaner before clearing brush bar obstructions.
Failure to do so could result in personal injury.
• Beware of sharp objects when clearing obstructions.
• Refit all parts of the vacuum cleaner securely before using.
PLeASe NOTe:
• Clearing brush bar obstructions is not covered by your vacuum cleaner's limited
warranty.