Series 3 Hopper Assembly; Assembly Instruction; Parts Included; Tools Required - Louisiana Grills cs 450 Owner's Manual

INSTALLING THE HOPPER & IGNITER

Parts Included:

Series 3 Hopper Assembly

Mounting hardware
2 x #10 x 16 x1/2" screws,
4 x 1/4 x 20 x 1/2" screws

Tools Required:

Phillips & Standard
Screwdrivers
Installation:
Step 1 Attaching the Igniter to the hopper:

Carefully remove the igniter and its packaging from inside
the hopper. Diagram A

Using your Phillips Screwdriver and the 2 (two)
#10 x 16 x 1/2" Phillips screws, secure the Igniter
to the outside of the hopper.
Step 2 Attaching the Grill Probe Wires:
Your Grill/Smoker comes complete with the "Digital Control Center"
complete with grill probe and meat probe. The grill probe has been
factory installed in the barrel, with the excess wire and connections run
out through the barrel end and threaded into the auger feed hole, for
shipping reasons. Diagram D
The wire connections to the board can be found inside or taped to the
outside of the hopper.

Ensure the probe wires are run only through the large hole
Located off to the right of the auger tube.

To connect, carefully lift the entire hopper and attached igniter, to the
left hand-side of the main barrel.

Begin by slightly inserting the igniter into the installed Burned Pot at the
bottom side of the barrel. Support the hopper on your leg as you connect
the two spade connections.
Diagram E

Carefully thread ALL excess wire, as well as the connections, back into the
hopper. The wiring must not come in contact with either the fan
blades, or the metal auger tube.

Assembly Instruction

1/4" Hex Nut
Driver, 5/16"
Hex Nut Driver
Phillips Screw Driver &
Cordless Drill
Diagram B
Diagram C
A
B
C
D
E
9