Drive Spitfire EX Quick Start Manual

1.
Remove your Spitfire Scooter from its
packaging. Loosen the tiller adjustment knob.
5.
Insert the seat post bolt into the hole at the base
of the seat tube so that the bolt passes all the
way through both the seat tube and the seat post to
the hole on the opposite side.
Tighten the bolt near the top of the seat tube with the
included Allen wrench.
Quick Start Guide
Spitfire EX 3 & 4 Wheel
2.
Raise the tiller to the upright position at the
desired angle and re-tighten the knob.
6.
Replace the battery pack, ensuring the battery
is firmly in place.
Please Read Before Operating!
For technical assistance, call toll free (866) 621-4933 or (800) 544-5155.
3.
Remove the battery pack by grasping the pack's
handle and pulling upward firmly.
7.
Attach the seat by lifting up on the handle on
the right side of the seat and placing the seat
down on the scooter's seat post. Release the handle
to lock the seat in place. When the seat is locked,
you will hear a click.
4.
Install the seat post into the seat tube in the
scooter's frame to the desired height.
8.
Fully charge the scooter's batteries by inserting
the round charger connector into the battery
charging terminal on the scooter's battery pack and
inserting the 3-pronged plug into a standard electrical
outlet.
Full charging normally takes 6-8 hours, but can take
as many as 10 hours depending on the batteries'
charge level when starting and the ambient
temperature.