Displaying Lldp Information Received From Lldp Neighbors; Lldp Configuration Example; Network Requirements; Configuring Switch A - HP 1920 Series User Manual

Displaying LLDP information received from LLDP
neighbors
1.
2.

LLDP configuration example

Network requirements

As shown in
status of the link between Switch A and MED and the link between Switch A and Switch B.
Figure 208 Network diagram

Configuring Switch A

1.
2.
Downloaded from www.Manualslib.com
From the navigation tree, select Network > LLDP.
Click the Neighbor Summary tab to display the global LLDP neighbor information, as shown
in Figure 207.
Figure 207 The neighbor summary tab
Figure 208, configure LLDP on Switch A and Switch B so that the NMS can determine the
(Optional.) Enable LLDP on GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2. By default, LLDP
is enabled on Ethernet ports.
Set the LLDP operating mode to Rx on GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2:
a. From the navigation tree, select Network > LLDP.
By default, the Port Setup tab is displayed, as shown in
b. Select port GigabitEthernet1/0/1 and GigabitEthernet1/0/2.
c. Click Modify Selected.
manuals search engine
Figure
236
209.