Related Manuals for Moen GEC9
Summary of Contents for Moen GEC9
- Page 1 GEC9 OWNER S MANUAL Be sure to read this manual before using the product in order to ensure safe operation.
-
Page 2: Overview
1- Overview Top Panel Rear Panel (1) PRESETS These switches instantly recall the settings stored in the corresponding PRESET 1-5 when pressed, press the active PRESET switch again will bypass whole loops. All presets are stored in nonvolatile memory, will not be erased even without power supply. (2) MUTE/CLEAN This switch instantly shuts off the LOOP OUT (LOUT1&LOUT2) and switches the INPUT to CLEAN jack, press it again will get back to normal operation. - Page 3 (7) BUF IN (Buffered Input) Signal input via this jack is fed to a buffer circuit prior to being sent to the loops. (8) DC Jack 5.5 x 2.1 mm type, use negative center DC 9V / 500mA power supply. (9) NBUF IN (Non Buffered input) This jack bypasses the buffer circuit and directly sends singal to the loops.
-
Page 4: Signal Path
OUT8 LOOP9 OUT9 Guitar signal feeds into GEC9 input (NBUF IN or BUF IN), enters series LOOP1~LOOP6 when MUTE switch is off, then outputs from LOUT1 and LOUT2. If MUTE is on, the signal outputs directly to CLEAN jack. The BUF OUT jack always outputs buffered input signal. -
Page 5: Specifications
8- Specifications Dimensions........16.9(L) x3.8(W)X1.22(H) inch Weight................1800g Power Supply...........DC9V (Negative Center) Current Drain............max. 350mA Input impedance............500K ohm Output impedance............10K ohm Max. Buffered Input Vp-p............9V Max. Non-Buffered Input Vp-p..........30V Typical Configuration 1 - Connect 9 pedals... -
Page 6: Separate Loops As Footswitch
Configuration 2 - Separate loops as footswitch In this configuration the separate loop send jack S7, S8, S9 are used to control the amplifier channels. The amplifier preamp is connected to GEC9 LOOP1, makes it possible to add modulation effects to the preamp. -
Page 7: Use Multiple Amplifiers
Configuration 3 - Use multiple amplifiers In this configuration, the separate loop9 is used to choose signal path to different amps. LOOP1 LOOP2 LOOP3 LOOP4 LOOP5 LOOP6 LOUT2 BUF IN DC9V NBUF IN LOUT1 S7 (N.C) BUF OUT (A.O.) CLEAN S8 (N.C) S9 (N.C) OUT9(N.O) -
Page 8: Control Pedals In Amp Ext. Loops
Configuration 4 - Control Pedals in AMP ext. loops This setup put 6 pedals (LP1,LP2,LP3,LP4,LP5,LP6) in front of AMP and 3 pedals (LP7,LP8,LP9) into AMP LOOP. Preset example (1=ON, 0=OFF): PRESET1 - LP1,LP2...LP7,LP8,LP9 = PRESET2 - LP1,LP2...LP7,LP8,LP9 = Pedals in front of AMP LOUT2 BUF IN BUF IN...