HP 250 G3 Maintenance And Service Manual page 82

a. Flex the inside of the top edge (1), the left and right edges (2), and the bottom edge (3) of the
display bezel until the bezel disengages from the display enclosure.
b. Remove the display bezel (4).
NOTE:
following image.
2. To remove the webcam/microphone module:
a. Position the display assembly with the top edge toward you.
b. Disconnect the cable (1) from the module.
c. Remove the webcam/microphone module (2). (The module is attached to the display enclosure
with double-sided tape.)
3. To remove the display panel:
a. Remove the four Phillips PM2.5×3.5 screws that secure the display panel to the enclosure.
74 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
In this procedure, the display will NOT be connected to the computer, as shown in the