HP 250 G3 Maintenance And Service Manual page 81

1. Disengage the adhesive and disconnect the display panel cable (1) from the system board.
2. Remove the display panel cable from its routing path (2).
3. Release the wireless antenna cables from the clips (3) built into the base enclosure.
CAUTION: Support the display assembly when removing the following screws. Failure to support the
display assembly can result in damage to the display assembly and other computer components.
4. Remove the four Phillips PM2.5×5.0 screws (1) (two from each hinge) and one Phillips PM2.5×3.5 screw
(2) (on the right hinge) that secures the display assembly to the computer.
5. Remove the display assembly (3).
If it is necessary to replace any of the display assembly subcomponents:
1. To remove the display bezel:
Component replacement procedures 73