Usb Board - HP 250 G3 Maintenance And Service Manual

USB board

Description
USB board (includes cable)
Before removing the USB board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
● Keyboard (see
● Top cover (see
● WLAN module (see
●
System board (see
● Hard drive (see
To remove the USB board:
1. Position the computer upright.
2. Disconnect the USB board cable from the system board (1).
3. Remove the tape that secures it to the cable to the base enclosure (2).
4. Remove the Phillips PM2.5×5.0 screw (3) that secures the USB board to the base enclosure.
5. Remove the USB board (4).
Reverse this procedure to install the USB board.
64 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 35), and then remove the following components:
Keyboard on page 39)
Top cover on page 47)
WLAN module on page
System board on page
Hard drive on page 53)
55)
60)
Spare part number
749649-001