Work Piece And Work Area Set Up - Chicago Electric 61481 Owner's Manual & Safety Instructions

Work Piece and Work Area Set Up

1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
Setting Up an Angle Cut
1. To cut at various angles (up to 45º),
adjust the Angle Scale (35) by loosening the
two Bolts (41) as shown in Figure F.
2. Adjust the Angle Scale to the desired
setting and then tighten both Bolts.
3. To reposition the Angle Scale for a wider workpiece,
remove both of the Bolts, and reattach the Angle
Scale at the upper two screw holes. See Figure F.
Page 10 For technical questions, please call 1-888-866-5797.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
3. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
Upper Two Screw Holes
Bolts (41)
Angle
Scale
(35)
Figure F: Angle Scale
Item 61481