Connecting Over Wifi; Connecting Using Ethernet Cable - NetComm NP127 Quick Start Manual

CONNECTING THE WIFI EXTENDER
1.
Ensure that the NP127 power switch is in the 'off' position and then plug the NP127 into a
power outlet which is close to your device (e.g. computer or smartphone).
2. Turn the power switch of the NP127 to the 'on' position. The NP127 starts up and the
Power LED illuminates. You may now access the NP127 using either WiFi or Ethernet.

Connecting over WiFi

1. Ensure WiFi is enabled on your wireless device (e.g. computer or smartphone) that will
connect to the router.
2. Scan for wireless networks in your area. If your device supports both 2.4GHz and 5GHz
networks then you will see both networks appear on the scanned list. Connect to the
network name that matches one of the Wireless network name found on the Wireless
Security Card (included in the box).
Note: For security purposes, each NetComm Wireless NP127 has a unique SSID (such as NetComm 7559) and
Wireless Security Key. The above image is for illustration only.
3. When prompted for your wireless security settings, enter the Wireless security key listed
on your Wireless Security Card.
4.
Wait approximately 30 seconds for the connection to establish.

Connecting using Ethernet Cable

Connect one end of the supplied RJ45 Ethernet cable to the Ethernet port on the bottom
panel of the NP127 and the other end to the Ethernet port of your computer. Wait for 30
seconds as your computer is assigned a local address by the WiFi Extender.
2.4GHz -
5GHz -
2.4GHz -
5GHz -
AC750 WiFi Extender - NP127