Device Overview; Front Panel; Bottom Panel - NetComm NP127 Quick Start Manual

DEVICE OVERVIEW

Front panel

The NP127 features 7 LEDs on the front panel and a WPS button. The top 5 LEDs give an
indication of the distance and strength of the signal between the NP127 and the connected
router. The signal strength LEDs only functions when the device is in repeater mode. The
images below describe the meaning of each indicator and button.
AC

Bottom panel

Reset
Off/On
NetCommWireless
Power
Ethernet
WPS
Reset button – press and hold this button for more than 3
second to restore the factory default settings of the NP127.
Ethernet port – Connect the supplied RJ45 Ethernet cable
here to set up the WiFi Extender.
Power switch – Turns the NP127 on or off.
The NP127 is located too far from the router to provide a
reliable signal.
The NP127 is located just out of the optimal range of the
connected router.
Optimal signal and distance from the connected router to
provide the widest coverage area for your network.
The NP127 has a good signal to the router but is too close
to maximize the coverage area.
The NP127 has a strong signal to the router but is too close
to maximize the coverage area.
When illuminated, indicates that the NP127 is correctly
powered and is switched on.
When illuminated, indicates that the NP127 is connected to
an active Ethernet connection.
WPS button/LED – Press and hold the WPS button for
between 1 and 2 seconds then release to trigger the WPS
connection when you are connecting a client device to the
NP127. Press and hold the button for between 4 and 9
seconds then release to trigger the WPS connection when
you are connecting the NP127 to a router. The WPS LED
blinks when the WPS process is triggered.