Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for NetComm NP127
Summary of Contents for NetComm NP127
- Page 1 QUICK START GUIDE NetCommWirele AC750 WiFi Extender NetCommWireless NP127...
-
Page 2: Package Contents
WELCOME Thank you for choosing a NetComm Wireless NP127 AC750 WiFi Extender. This guide will help you set up, connect and configure your device quickly and easily. PACKAGE CONTENTS The NP127 package includes: 1 x NetComm Wireless NP127 Dual AC750 WiFi Extender... -
Page 3: How It Works
Router Smartphone Access Point mode – the NP127 connects to an existing router via Ethernet and provides a wireless signal for wireless devices. This is useful in situations where there is no existing wireless access point or where you wish to provide a wireless signal to a remote area (up to 100 metres) from where the router is located. -
Page 4: Device Overview
DEVICE OVERVIEW Front panel The NP127 features 7 LEDs on the front panel and a WPS button. The top 5 LEDs give an indication of the distance and strength of the signal between the NP127 and the connected router. The signal strength LEDs only functions when the device is in repeater mode. The images below describe the meaning of each indicator and button. -
Page 5: Connecting Over Wifi
CONNECTING THE WIFI EXTENDER Ensure that the NP127 power switch is in the ‘off’ position and then plug the NP127 into a power outlet which is close to your device (e.g. computer or smartphone). Turn the power switch of the NP127 to the ‘on’ position. The NP127 starts up and the Power LED illuminates. -
Page 6: Logging Into The Web Interface
CONNECTING THE NP127 TO YOUR ROUTER Repeater Mode Upon logging in to the NP127 web interface, you are presented with the Connection Wizard screen. Click the Start button at the bottom of the screen to begin connecting the WiFi Extender to your broadband hub/router. -
Page 7: Access Point Mode
Click the OK button. The connection wizard is complete. To access the NP127 user interface in the future, connect an Ethernet cable to the Ethernet port on the NP127, then enter http://my.extender into the address bar. Access Point Mode... - Page 8 Slide the power switch to the ‘off’ position and remove the NP127 from the wall socket. Plug the NP127 into a wall socket in the centre of the area that you would like to cover which is also within range of the router. Turn the power switch to the ‘on’ position. Wait approximately 30 seconds for the NP127 to power up and connect to the router.