Connect To An Existing Wifi Network; Place The Extender And Apply Power; Use The Extender - NETGEAR EX2700 Quick Start Manual

Use the Extender

The extender repeats the signals from an existing WiFi router or access
point. Place the extender, apply power, and connect it to your WiFi
network.

Place the Extender and Apply Power

1. Place your extender in the same room as your WiFi router.
Proximity to the WiFi router is required only during the initial setup
process.
2. Plug the extender into an electrical outlet.
Wait for the Power LED to light green.
3. If the Power LED does not light, press the Power On/Off button on
the extender.

Connect to an Existing WiFi Network

To extend the range of your WiFi network, you must connect the extender
to your existing WiFi network. You can do this in one of two ways:
• Connect with WPS. For more information, see
page 6.
• Connect with web browser setup. For more information, see
Connect with Web Browser Setup on page 8.
5
Connect with WPS on