System Configuration - Acer AX1400 Service Manual

Virus-related
Message
BootSector Write!!
VIRUS: Continue 
(Y/N)?

System Configuration

Message
DMA-1 Error
DMA-2 Error
DMA Controller Error
Checking NVRAM...
Update Failed
Microcode Error
NVRAM Checksum
Bad, NVRAM
Cleared
Resource Conflict
NVRAM Ignored
NVRAM Bad
Static Resource
Conflict
PCI I/O conflict
PCI ROM conflict
PCI IRQ conflict
PCI IRQ routing table
error
Timer Error
Refresh timer test
failed
Interrupt Controller-1
error
Interrupt Controller-2
error
54
Description
The BIOS has detected software attempting to write to a drive's boot sector. This is
flagged as possible virus activity. This message will only be displayed if Virus
Detection is enabled in AMIBIOS setup.
If the BIOS detects possible virus activity, it will prompt the user. This message will
only be displayed if Virus Detection is enabled in AMIBIOS setup.
Description
Error initializing primary DMA controller. This is a fatal error, often indication a
problem with system hardware.
Error initializing secondary DMA controller. This is a fatal error, often indication a
problem with system hardware.
POST error while trying to initialize the DMA controller. This is a fatal error, often
indication a problem with system hardware.
BIOS could not write to the NVRAM block. This message appears when the FLASH
part is write-protected or if there is no FLASH part (System uses a PROM or
EPROM).
BIOS could not find or load the CPU Microcode Update to the CPU. This message
only applies to INTEL CPUs. The message is most likely to appear when a brand
new CPU is installed in a mainboard with an outdated BIOS. In this case, the BIOS
must be updated to include the Microcode Update for the new CPU.
There was an error in while validating the NVRAM data. This causes POST to clear
the NVRAM data.
More than one system device is trying to use the same non-shareable resources
(Memory or I/O).
The NVRAM data used to store Plug'n'Play (PnP) data was not used for system
configuration in POST.
The NVRAM data used to store Plug'n'Play (PnP) data was not used for system
configuration in POST due to a data error.
Two or more Static Devices are trying to use the same resource space (usually
Memory or I/O).
A PCI adapter generated an I/O resource conflict when configured by BIOS POST.
A PCI adapter generated an I/O resource conflict when configured by BIOS POST.
A PCI adapter generated an I/O resource conflict when configured by BIOS POST.
BIOS POST (DIM code) found a PCI device in the system but was unable to figure
out how to route an IRQ to the device. Usually this error is causing by an
incomplete description of the PCI Interrupt Routing of the system.
Indicates an error while programming the count register of channel 2 of the 8254
timer. This may indicate a problem with system hardware.
BIOS POST found that the refresh timer hardware failed to pass the Refresh
Retrace Test.
BIOS POST could not initialize the Master Interrupt Controller. This may indicate a
problem with system hardware.
BIOS POST could not initialize the Slave Interrupt Controller. This may indicate a
problem with system hardware.
Aspire AX1400 Service Guide