Dryer Care; Cleaning The Dryer Location; Cleaning The Lint Screen - Maytag Epic W10139629A Use And Care Manual

4. Close the door.
5. Select a Manual cycle, and choose a temperature or Air Only (see following chart). Items
containing foam, rubber or plastic must be dried on a clothesline or by using the Air Only
temperature setting.
6. You must select a time by pressing the MANUAL DRY TIME (- or +) buttons. Reset time as
needed to complete drying. Refer to the following table.
7. Press (and hold) HOLD TO START button (about 1 second).
NOTE: You must remove rack for normal tumbling. Do not use automatic cycles with the
drying rack.
This chart shows examples of items that can be rack dried and the suggested cycle,
temperature setting and drying time. Actual drying time will depend on the amount of
moisture items hold.

Cleaning the Dryer Location

Keep dryer area clear and free from items that would obstruct the flow of combustion and
ventilation air.
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the floor
for a garage installation.
Failure to do so can result in death, explosion, or fire.

Cleaning the Lint Screen

Every load cleaning
The lint screen is located in the door opening of the dryer. A screen blocked by lint can
increase drying time.
Rack Dry
Wool Sweaters
Block to shape and lay flat on the rack
Stuffed toys or pillows
Cotton or polyester fiber filled
Stuffed toys or pillows
Foam rubber filled
Sneakers or canvas shoes
*(Minutes) Reset time to complete drying, if needed.

DRYER CARE

To clean
1. Pull the lint screen straight up. Roll lint off the screen with your fingers. Do not rinse or
wash screen to remove lint. Wet lint is hard to remove.
2. Push the lint screen firmly back into place.
IMPORTANT:
Do not run the dryer with the lint screen loose, damaged, blocked, or missing. Doing so
can cause overheating and damage to both the dryer and fabrics.
If lint falls off the screen into the dryer during removal, check the exhaust hood and
remove the lint. See "Venting Requirements."
As needed cleaning
Laundry detergent and fabric softener residue can build up on the lint screen. This buildup
can cause longer drying times for your clothes, or cause the dryer to stop before your load is
completely dry. The screen is probably clogged if lint falls off while the screen is in the dryer.
Clean the lint screen with a nylon brush every 6 months, or more frequently, if it becomes
clogged due to a residue buildup.
To wash
1. Roll lint off the screen with your fingers.
2. Wet both sides of lint screen with hot water.
Setting Temp. Time*
Timed Dry Low 60
Timed Dry Low 60
Timed Dry Air Only 90
(no heat)
Timed Dry Air Only 90
(no heat)
27