Installation Instructions; Tools And Parts; Location Requirements - Maytag Bravos W10201177B Use And Care Manual

Tools and Parts

Gather the required tools and parts before starting installation. Read and follow the
instructions provided with any tools listed here.
■ Flat-blade screwdriver
■ Adjustable wrench that opens to
1" (25 mm) or hex-head socket wrench
(for adjusting dryer feet)
■ 8" or 10" pipe wrench
■ 8" or 10" adjustable wrench (for gas
connections)
■ Pipe-joint compound resistant to LP gas
■ Pliers
Parts supplied:
Remove parts package from dryer drum. Check that all parts were included.
A B
A. Leveling legs (4)
B. "Y" connector
C. Short inlet hose
D. Long inlet hose
E. Rubber washer
Parts needed:
Check local codes. Check existing electrical supply and venting and see "Electrical
Requirements" and "Venting Requirements" before purchasing parts.

INSTALLATION INSTRUCTIONS

■ Tin snips (new vent installation)
■ Level
■ Vent clamps
■ Caulking gun and compound (for
installing new exhaust vent)
■ Tape measure
■ Knife
C E
D
Mobile home installations require metal exhaust system hardware available for purchase from
the dealer from whom you purchased your dryer. For information on ordering, please refer to
the "Assistance or Service" section. You may also contact the dealer from whom you
purchased your dryer.
Mobile home installation kit. Ask for Part Number 346764.
■
Metal exhaust system hardware.
■

Location Requirements

You will need
■ A location that allows for proper exhaust installation. See "Venting Requirements."
■ If you are using a power supply cord, a grounded electrical outlet located within
2 ft (610 mm) of either side of the dryer. See "Electrical Requirements."
■ A sturdy floor to support the total weight (dryer and load) of 200 lbs (90.7 kg). The
combined weight of a companion appliance should also be considered.
■ Cold water faucets located within 4 ft (1.2 m) of the water fill valves, and water pressure
of 20-100 psi (138-690 kPa). You may use the water supply for your washer using the "Y"
connector and short hose (if needed) which are provided.
■ 20-100 psi (138-690 kPa) for best performance.
■ A level floor with a maximum slope of 1" (25 mm) under entire dryer.
5