Healthy Airflow Operation - Haier HSU-09HEG03/R2(DB) Service Manual

Hide thumbs Also See for HSU-09HEG03/R2(DB):
Table of Contents

Advertisement

Operation
Timer On/Off On-Off Operation
1.After unit starts, select your desired operation mode.
2.Press TIMER button to change TIMER mode. Every
time the button is pressed, display changes as follows:
Remote controller:
0.5h
0.5h
TIMER ON TIMER OFF
TIMER ON-OFF
Then select your desired TIMER mode (TIMER ON or
TIMER OFF or TIMER ON-OFF). "
3.Press
/
button to set time.
Press the button for each time, setting time in the first
12 hours increased by 0.5 hour every time, after 12
hours,increased by 1 hour every time.
Press the button for each time, settiing time in the first
12 hours decreased by 0.5 hour every time, after 12
hours,decreased by 1 hour every time.
It can be adjusted within 24 hours.
4.Confirm timer setting
After adjusting the time,press
the time the ON or OFF button will not flash any more.
5.Cancel timer setting
Press the timer button until the time display eliminated.
Hints:
After replacing batteries or a power failure happens, time
setting should be reset.
According to the Time setting sequence of TIMER ON or
TIMER OFF, either Start-Stop or Stop-Start can be achieved.
BLANK
0.5h
0.5h
TIMER OFF-ON
"or "
"will flash.
button and confirm

Healthy airflow Operation

1.Press
to starting
Setting for comfortable conditions.
2.The setting of healthy airflow function
Press
button to enter additional options,Press this
button continuously, the louvers location will cycle between
in the following three locations, to choose the swing location
what you needed,and then press
Healthy
airflow
upwarder
3.To cancel of the healthy airflow function
Press
button to enter additional options,Press this
button continuously, the louvers location will cycle between
the three locations again,and then press
cancel.
Notice: Do not direct the horizontal by hand. This may cause
the louver to run incorrectly and not match the display. If the
louver is not running correctly, stop the unit
and then restart and adjust remote controller.
Note:
1.After setting the healthy airflow function, the position
louver is fixed.
2.In heating, it is better to select the
3.In cooling, it is better to select the
4.In cooling and dry, using the air conditioner for a long
time under the high air humidity, condensate water may
occur at the grille .
45
Function and control
button to confirm.
Healthy
Present
airflow
position
downwarder
button to
for a minute
mode.
mode.
Domestic Air Conditioner

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hsu09vhg(db)

Table of Contents