Maintenance Schedule; Blades - Honda HRX217VKA Owner's Manual

• Read the instructions before you begin, and make sure you have
the tools and skills required.
• To reduce the possibility of fire or explosion, be careful when
working around gasoline. Use only a nonflammable solvent, not
gasoline, to clean parts. Keep cigarettes, sparks, and flames away
from all fuel-related parts.

MAINTENANCE SCHEDULE

Interval
Before each use Inspect the blades (page 9)
Check the blade bolt torque (page 10)
Check the rear shield (page 6)
Check the grass bag (page 6)
Check the engine oil level (page 11)
Check the air cleaner (page 11)
Check operation of the blade control cable
(page 12)
First month or Change the engine oil (page 11)
5 hours
First 25 hours Clean the air filter element (page 11)
Adjust the Smart Drive cable
Every 50 hours Change the engine oil (page 11)
Clean the air filter element (page 11)
Adjust the Smart Drive cable
Every 100 hours Change the engine oil (page 11)
Clean the air filter element (page 11)
Check-adjust the spark plug (page 12)
Clean the spark arrester (optional)(page 12)
Grease the pinion gears
Check the flywheel brake pad
Adjust the Smart Drive cable
Every 150 hours Change the engine oil (page 11)
Replace the air cleaner filter (page 11)
Replace the spark plug (page 12)
Adjust the Smart Drive cable
Adjust the valve clearance
Adjust the idle speed
Clean the fuel tank
After every 250 Clean the combustion chamber
hours
Every 2 years Check the fuel line and replace if necessary
1. Service more frequently when used in dusty areas.
2. These items should be serviced by an authorized Honda servicing
dealer unless you have the proper tools and are mechanically
proficient. Refer to the Honda shop manual for service procedures.
Failure to follow this maintenance schedule could result in
non-warrantable failures.
Item
1
2
1
1
2
1
1
2
2
2
1
2
2
2
2
2
2

BLADES

Inspection
1. Move the fuel valve to the OFF
position (page 7) and
disconnect the spark plug cap
from the spark plug (page 12).
2. Tilt the mower to the right so the
fuel cap is up. This will help
prevent fuel leakage, motor oil
seeping into the air filter and
hard starting.
3. Inspect the blades for damage, cracks, and excessive wear, rust,
or corrosion.
BLADES
BLADE BOLTS
GOOD WORN
B
WARNING
A worn, cracked, or damaged blade can break, and pieces
of the damaged blade can become dangerous projectiles.
Thrown objects can cause serious injury.
Inspect the blades regularly, and do not operate the mower
with a worn or damaged blade.
A dull blade can be sharpened, but a blade that is excessively
worn, bent, cracked, or otherwise damaged must be replaced. A
worn or damaged blade can break, causing blade pieces to be
thrown from the mower.
If a blade is bent, take the lawn mower to an authorized Honda
servicing dealer for inspection.
4. Always use a torque wrench when installing the blades. Check that
the blade bolts are tight.
Blade Removal and Installation
If you remove the blades for sharpening or replacement, you will need
a torque wrench for installation. Wear heavy gloves to protect your
hands.
BLADE SHARPENING: To avoid weakening the blades or causing
imbalance or poor cutting, the blades should be sharpened by trained
staff at an authorized Honda servicing dealer.
BLADE REPLACEMENT: Use Honda Genuine replacement blades or
their equivalent (page 18).
FUEL CAP UP
BENT CRACKED
9