Table of Contents
Advertisement
Available languages
Available languages
Adjust Flame Height
Adjust Surface Burner Flame
Adjust the height of top burner flames. The cooktop “low”
burner flame should be a steady blue flame approximately ¼"
(6 mm) high. LP gas flames have a slightly yellow tip.
A
B
A. Low flame
B. High flame
To Adjust Standard Burner:
The flame can be adjusted using the adjustment screw
in the center of the valve stem. The valve stem is located
directly underneath the control knob.
If the “Low” Flame Needs to be Adjusted:
1. Light one burner and turn to lowest setting.
2. Remove the control knob.
Hold the knob stem with a pair of pliers. Use a small
flat-blade screwdriver to turn the screw located in the center
of the control knob stem until the flame is the proper size.
Turning the screw clockwise will increase the flame size,
and turning the screw counterclockwise will decrease
the flame size.
A
B
C
A. Control knob stem
B. Screwdriver
C. Pliers
3. Replace the control knob.
4. Test the flame by turning the control from the low position
to the high position, checking the flame at each setting.
5. Repeat the previous steps for each burner.
To Adjust Double Burner (On Some Models):
1. Light burner and turn to lowest setting where both inner
and outer burners are lit.
2. Remove the control knob.
Hold the knob stem with a pair of pliers. Use a small
flat-blade screwdriver to turn the screw located in the center
of the control knob stem until the flame is the proper size.
Turning the screw clockwise will increase the flame size,
and turning the screw counterclockwise will decrease
the flame size.
A
B
C
A. Control knob stem
B. Screwdriver
C. Pliers
3. Replace the control knob.
4. Test the flame by turning the control from the low position
to the high position, checking the flame at each setting.
Page 26
Hide quick links:
Advertisement
Table of Contents
