Setup - Honeywell MX9 User Manual

Setup

Prerequisite: The AC Adapter is assembled and receiving AC power.
The battery charger should be located in an area where it:
Is well ventilated.
l
Is not in high traffic areas.
l
Locates or orients the AC cord so that it will not be stepped on, tripped over or subjected to damage or stress.
l
Has enough clearance to allow easy access to the power port on the back of the device.
l
Is protected from rain, dust, direct sunlight or inclement weather.
l
This device is intended for indoor use only and requires an indoor AC power source. The charger is not approved for use in
Hazardous Locations.
Place the battery charger on a flat, horizontal, hard surface or fasten securely to a stable surface using the keyhole openings on
the bottom of the battery charger.
Do not insert battery packs until the battery charger has finished powering up:
Insert the power connector into the power outlet at the back of the battery charger.
l
AC power is now being applied to the battery charger and it begins to power up.
l
Charge pocket LEDs flash while the battery charger enters and exits the startup check.
l
When the charge pocket LEDs are not illuminated, the battery charger is ready for use.
l
1-5