Braeburn 1020NC Installation Manual page 6

Non-programmable

Hide thumbs Also See for 1020NC:

Table of Contents

Heat Pump Systems

NOTES - Heat Pump Systems

[1] If batteries are installed the 24 Volt AC common connection is optional.

[2] Select O for cool active or B for heat active.

[3] Install a field supplied jumper between the W2 and E terminals if

there is no separate emergency heat relay installed.

Provide disconnect and overload protection as required.

Set Installer Switches

Switch

CONV / HP

F / C

HE / HG

NOTE: The reset button should be pressed after making any changes to the

installer switches.

Attach Thermostat to Sub-Base

1. Line up the thermostat body with the sub-base.

2. Carefully push the thermostat body against the sub-base until it snaps

into place.

3. Insert quick reference card into slot on top of thermostat.

Factory Setting

Default Options Comments

CONV

(cont.)

Select for conventional systems

Select for heat pump systems

Select for fahrenheit temperature scale

Select for celsius temperature scale

Select for gas heat

Select for electric heat

Table of Contents

Show Quick Links

Table of Contents

1220nc