Configuring The Optional Ikvm Switch Module; Enabling Ikvm Access To The Dell Cmc Console; Updating The Ikvm Firmware - Dell PowerEdge M1000e Configuration Manual

7 Click Yes to continue. The firmware transfer process will begin and the
status will display the message "Firmware Update in Progress". Once the
CMC update is complete, the CMC will be reset. Once the reset is
complete, you will need to refresh the User Interface page to then log in
again.
Updating the CMC Firmware Using RACADM
1 Open a CMC command line console and log in.
2 Type:
racadm fwupdate -g -u -a <TFTP server IP address>
-d <filepath> -m <cmc-active|cmc-standby>
See the latest Dell Chassis Management Controller User's Guide at
support.dell.com for complete instructions on how to configure and operate
the CMC module.

Configuring the Optional iKVM Switch Module

Enabling iKVM Access to the Dell CMC Console

Enabling access to the CMC allows you to access the CMC directly and
securely through the iKVM's CMC Console option. To enable the CMC
Console using the Web-based interface:
1 Log in to the CMC Web-based interface.
2 Select iKVM in the system tree. The iKVM Status page displays.
3 Click the Setup tab. The iKVM Configuration page displays.
4 Select Allow access to CMC CLI from iKVM.
5 Click Apply to save the setting.

Updating the iKVM Firmware

NOTE:
The iKVM resets and becomes temporarily unavailable after the firmware
has been uploaded successfully.
1 Log in to the CMC's Web-based interface. See "Logging in to the CMC
Using the Web-Based Interface" on page 25.
2 Select Chassis in the system tree.
Configuration Guide
31