Electrical Connection - Miele CVA6805 Operating And Installation Instructions

Electrical connection

Make sure that the power to the ma‐
chine is OFF before installing or per‐
forming maintenance or repairs. All
electrical work should be performed by
a qualified electrician in strict accord‐
ance with national and local safety reg‐
ulations. Installation, repairs and other
work by unqualified persons could be
dangerous.
Verify that the voltage, load and circuit
rating information found on the data
plate match the household electrical
supply. This data must match to pre‐
vent damage to the coffee system. If in
doubt, consult a licensed electrician.
The necessary connection information
is given on the data plate inside your
appliance.
The coffee system comes equipped
with a 6 ft (1.8 m) power cord with a
NEMA 5-15P molded plug for connec‐
tion to a 120 V, 15 A, 60 Hz power sup‐
ply.
Fuse rating must be at least 16 A.
Do not connect the appliance to a pow‐
er inverter or directly to power pro‐
duced outside of the normal electrical
grid (i.e. direct solar or wind power
source).
Direct connection to such power sour‐
ces can cause power surges and trip‐
ped breakers when the appliance is
turned on, and could damage the appli‐
ance.
Do not connect the appliance to energy
saving plugs or outlets. The reduction
of power to the appliance caused by
these devices will cause the appliance
to run hot and may damage it and/or
shorten its usable life.
98
If there is any question concerning the
electrical connection of this appliance
to your power supply, please consult a
licensed electrician or contact Miele's
Technical Service Department. See
back page for contact information.
WARNING:
THIS APPLIANCE MUST BE GROUND‐
ED