Threading the upper thread
1
2
4
3
5
6
Changing the needle
⦁
raise the needle and presser foot
⦁
turn power switch to «0» (off)
⦁
place foam pad on the spool pin
⦁
place spool on pin so that the thread unwinds clockwise
⦁
attach appropriate spool disc
⦁
take thread through rear guide 1
⦁
then into slit of upper thread tension 2
⦁
pull thread down to the right of the take-up cover and around 3
⦁
take thread up to the left of the cover and around 4, placing it in the take-up
lever
⦁
take thread down and through guides 5 and 6
⦁
thread the needle (see page 27)
Appropriate spool disc
Diameter of thread spool determines disc size. There must be no
gap between the disc and the spool.
3
5
6
Removing the needle
⦁
raise the needle
⦁
lower or remove presser foot (see page 27)
⦁
turn power switch to «0» (off)
⦁
loosen the needle clamp screw
⦁
pull the needle down to remove
Inserting the needle
⦁
flat side of needle to the back
⦁
insert the needle as far as it will go
⦁
tighten needle clamp screw
0365315.0.04_2015-05_Manual_B570QE-B555_EN
Sewing preparation
25