Rinse Aid Dispenser - Haier ESD300 User Manual

English

RINSE AID DISPENSER

Rinse aids prevent water from forming droplets that can dry as spots or streaks.
They also improve drying by allowing water to drain off of the dishes during the
final rinse by releasing a small amount of the rinse aid into the rinse water. Your
dishwasher is designed to use a liquid rinse aid. Do not use a solid or bar-type.
FILLING THE DISPENSER
The rinse aid dispenser holds 4.8 oz ( 145ml ) of rinse aid. Under normal
conditions, this will last for about three months. Rinse aid is released through an
opening in the dispenser. You do not to wait until the dispenser is empty to refill
it. Try to keep it full, but be careful not to overfill it.
1. Make sure the dishwasher door is fully open.
2. Open the dispenser by pushing the cover latch.
3. Add rinse aid until the indicator window looks full.
4. Clean up any spilled rinse aid with a damp cloth.
5. Close the cover.
RINSE AID SETTING
The amount of rinse aid released into the final wash can be adjusted. The factory
setting is at 2. For most water conditions, set the adjuster to 2 or 3. If there are
rings or calcium ( hard water ) spots on dishes, try a higher setting.
TO ADJUST THE SETTING
Open the dispenser cover. Turn the adjuster inside the dispenser to the desired
setting .
16