Mixer Section; Effect Section - Pioneer DDJ-SX2 Operating Instructions Manual

Mixer section

1 2 1 2
INST. DOUBLES INST. DOUBLES
3
5
4
5
6
7
8
9
a
1 FX 1 assign button
Turns the effect unit FX1 on/off.
2 FX 2 assign button
Turns the effect unit FX2 on/off.
3 TRIM control
Adjusts the output size.
4 EQ (HI, MID, LOW) controls
Boosts or cuts frequencies.
5 Channel Level Indicator
Displays the sound level of the respective channels before passing
through the channel faders.
6 FILTER control
Applies the filter effect.
7 Headphones CUE/MIC TALK OVER button
The sound of channels for which the headphones [CUE] button is
pressed is output to the headphones.
When the [INPUT SELECT] switch for Channel 3 or Channel 4 is set
to [MIC1] or [MIC2], the talk over function can be turned on/off using
the switch.
[SHIFT] + press:
The track's tempo can be set by tapping the button. (Tap function)
8 Headphones CUE button
The sound of channels for which the headphones [CUE] button is
pressed is output to the headphones.
[SHIFT] + press:
The track's tempo can be set by tapping the button. (Tap function)
9 Channel fader
Move:
Adjusts the level of audio signals output in each channel.
[SHIFT] + move:
Use the channel fader start function.
10
En
1 2 1 2
INST. DOUBLES INST. DOUBLES
3
c
5
4
d
4 4
5
e
f
6
7
8
g
9
h
a
b
a Crossfader Assign Switch
Assigns the channel output to the crossfader.
b Crossfader
Outputs the sound assigned with the crossfader assign switch.
[SHIFT] + move:
Uses the crossfader start function.
c MASTER LEVEL control
Adjusts the master sound level output.
d Master level indicator
Displays the master output's audio level.
e Booth monitor level control
Adjusts the level of audio signals output from the [BOOTH OUT]
terminal.
f HEADPHONES MIX control
Adjusts the balance of the monitor volume between the sound of the
channels for which the headphones [CUE] button is pressed and the
sound of the master channel.
g MASTER CUE button
Turns monitoring of the master output's sound on and off.
h SAMPLER VOLUME fader
Adjusts the sampler's overall sound level.

Effect section

1 1
3 3
1 Effect parameter controls
These adjust the effects' parameters.
2 FX BEATS control
Adjusts the effect time.
3 Effect parameter buttons
Turns the effect on and off or switches the parameter.
[SHIFT] + press:
Switches the effect type.
4 TAP button
The BPM used as the base value for the effect is calculated by the
interval at which the button is tapped with a finger.
When the button is pressed and held, the effect time is reset.
[SHIFT] + press:
Switches the effect mode.
1 2
3 4