machine. When you call the machine and enter your remote access code (three digits followed by *), the system will
give two short beeps and you must enter a Remote Command (column 1), followed by one of the options (column 2)
for that command.
Change the Fax Forwarding, or Fax
2 Fax Forwarding
4 Fax Forwarding number
6 Fax Storage
Retrieve a fax
2 Retrieve all faxes
3 Erase faxes from memory
Check the receiving status
Change the Receive Mode
1 External TAD
3 Fax Only
Forward Faxes Remotely
Related Models:Dell E515dn / Dell E515dw
Call your Dell machine from any touch-tone telephone or fax machine to forward incoming faxes to another
You must turn on Fax Storage to use this feature.
1. Dial your fax number.
2. When your machine answers, enter your Remote Access Code (three digits followed by *). If you hear one long
beep, you have messages.
3. When you hear two short beeps, press 9 6 2.
4. Wait for the long beep, and then use the dial pad to enter the number of the remote fax machine where you
You can select Off after you retrieve or erase all your
One long beep means the change is accepted. If you
hear three short beeps, you cannot make a change
because something has not been set up (for example,
a Fax Forwarding number has not been registered).
You can register your Fax Forwarding number by
entering 4. After you register the number, Fax
Forwarding will work.
Enter the fax number of a remote fax machine to
receive stored fax messages.
If you hear one long beep, fax messages have been
erased from memory.
Check whether your machine has received any faxes.
If yes, you will hear one long beep. If not, you will
hear three short beeps.
One long beep means the change has been accepted.
Press 9 0 to stop remote retrieval. Wait for the long
beep, then hang up.